In your web browser, enter the IP address to access the device page. You also need a laptop or mobile device with a browser and an Internet connection. Verify that your static IP address is unique and not used by another device. We recommend that you complete the following tasks before you configure your static IP address:Д¬onnect your device to your network and register or activate it. You can only set a device's static IP before you register You cannot change the setting for static IP after the device registers. Then do a factory reset and repeat the configuration task. You are successful when the new address loads on your browser and the device registers or activates.

Some administrators prefer static IP addresses because they can assign specific addresses to each location or device. DHCP is the default, but you can configure a static or fixed IP address if you want your address to remain the Your device uses Dynamic Host Configuration Protocol (DHCP) for IP addresses, which means that the address may change when Select your device from the inventory and open Advanced Configurations.ДЄdd a Certificate Authority or Root Certificate Configure a Static IP Address With a Trusted Certificate Authority signature, then you don't share your certificate.ДЇrom the customer view in, go to Devices. If you have a local Appspace server and a certificate If your Appspace server usesДЄ self-signed certificate, then you share the certificate with Webex Share. You need an Appspace administrator account and an HTTP secure URL for your Appspace channel. This is the delay before the device enters Sleep mode.ДЇor more information, see the Appspace documentation for Digital Signage at Before you begin Standby > Delay resets to 120 minutes and Sleep mode. For additional information, see the documentation that came with your TV.ДЄfter you configure Digital Signage, the following Standby settings change: For example, some display manufactures let you lower your Sharpness setting or change Picture Mode to Computer or the equivalent. If your static images appear distorted or of a poor quality, Your screen display settings affect your Digital Signage images. Normal video playback resumes when Webex Share receives the next video.Дisable Low Bandwidth Mode if you stream video. The video will not play if you exceed these

Maximum resolution of 1920x1080 and a maximum frame rate of 30 frames per second. The recommended H.264 settings for video are as follows: If you use Handbrake to encode your video, select the zerolatency tune parameter. If you use video, note the following specifications: The supported static image file formats are. If you upload an image that is bigger, Appspace resizes it. If you use static images, note the following specifications: Images donвЂ™t appear during meetings, screen sharing, or during upcoming Webex Share enters signage mode after 2 minutes of inactivity.

You can display advertising content and promote your brand, but also show visitor and internal employee announcementsДigital signage requires access to Appspace.

Configure Digital Signage on Cisco Webex ShareД¬onfigure Digital Signage on Cisco Webex ShareДigital signage allows you to show custom video and static images on your display screen in between meetings or when Cisco Webex Share is idle.

For additional information, see the documentation that came with your display screen. For example, you can adjust the Sharpness setting or change Picture Mode to Computer or the equivalent. But on some display screens, shared images distort so you may have to adjust This feature does not require any configuration. Users share content wirelessly to any Webex registered room device without an account. You can see the meetings scheduled in your conference room.ДЇor additional information, see Add the Calendar Service. You can show custom content on your display, such as advertising content and brand information, visitor and internal employee Refer to the screen documentation for additional information. Some Cisco Webex Share features require Consumer Electronics Control (CEC) so connect your Webex Share to a HDMI-CEC port on your display screen. The following table shows some of the supported features.

Return Materials Authorization ChecklistДЄfter you add Cisco Webex Share to Cisco Webex Control Hub, you can add functionality to the device.

Webex admin url